User guide

Conditional Access
D.5 Configuring the MX8400 Multiplexer Static Parameters
The CA settings on the MX8400 Multiplexer are set in the Static Parameters in the
Physical Map. Each multiplexer has its own set of Static Parameters which must be
entered separately.
Table D.4 Configuring the MX8400 Multiplexer Static Parameters
Step Action Result Comments
1
In nCompass Control,
Equipment Setup, load
the required Physical Map
offline
Displays a map
view in which to
make changes.
Use File, Open to display an offline version of
the map.
2
From the list of devices,
select the required
MX8400 Multiplexer icon
and drag and drop it onto
the map.
Right-click the copied icon
to display a contextually-
sensitive menu.
Displays the
Multiplexer
properties
If the live physical map is displayed, some
buttons shown in Figure D.7 are unavailable
3
Click Read from Device to
read the Static Parameters
that are set on the device
Reads the Static
Parameters from
the MX8400
Multiplexer and
displays them
2/1553-FGC 101 1014 Uen B
D-13