User guide

Conditional Access
D.4.3.4 EMM DVB Simulcrypt Injector Dialog Box: EMM Injector Tab
Table D.3 Set Up an EMM Generator (continued)
Step Action Result Comments
5 Click the EMM Injector Tab
Enter the IP address of the
EMMG
Enter the required CA
System ID.
If the CASID is not on the drop-down list in the
GUI, type it in.
6
Enter the CA Subsystem ID
The CA vendor
supplies this
information.
Each vendor can allocate a CA Subsystem ID
in the range 00-FF. It is a two byte
hexadecimal number. This is to differentiate
between systems supplied by the same
vendor.
D.4.3.5 EMM DVB Simulcrypt Injector Dialog Box: CA Types Tab
Table D.3 Set Up an EMM Generator (continued)
Step Action Result Comments
7 Click the CA Types Tab
8
Select the required CA Type
from the list
The CA Types
setting enables
nCompass to
map services to
specific EMM
generators.
If you are using only one CA type, Any is
used.
If you are scrambling using more than one
type of CA, the list on the right should show
the CA types defined earlier in Section D.4.1.
2/1553-FGC 101 1014 Uen B
D-11