User guide

Conditional Access
D.4.3 Set Up an EMM Generator
D.4.3.1 Streaming EMMs to Multiple Output Transport Stream
MX8400 Release 5 allows a single EMMG connection providing a single EMM
stream to be distributed to all the required output transport streams.
Note: Refer to the nCC Setup information for further details.
• The EMM is currently defined in the Service Plan in each output Transport
Stream. This continues to be the case to allow for backward compatibility.
• The MX8400 identifies EMMs which are unique to one output transport stream.
• The MX8400 identifies EMMs which are common to multiple output transport
streams.
• A single EMMG connection is made for those EMMs that are shared across
multiple output streams.
• Where EMMs are shared across multiple output streams, each stream is
allocated the same EMM bit rate by nCC within the service plan.
• Where EMMs are shared across multiple output streams, MX8400 output
transport stream isolation applies.
Note: Where EMMs are shared across multiple output transport streams, any
corruption of the EMM input stream affects all output transport streams.
D.4.3.2 EMM/PD Capabilities
• 8 EMMG/PDG TCP/IP connections( Simulcrypt channels) per a MX8400 chassis
(8 shared between EMMG and PDG connections)
• 16 EMM streams per an EMMG/PDG TCP connection.
• 2 Mbps combined of EMM/PD per multiplexer engine.
• Maximum of 8 Mbps of EMM/PD as measured by the MX8400 in total.
• TCP control and delivery + TCP control and UDP delivery
• Single shared EMM TCP port for all connections
• Single shared EMM UDP port for all connections
D.4.3.3 EMM DVB Simulcrypt Injector Dialog Box: Device Tab
This section describes how to set up an EMMG in nCompass Control.
2/1553-FGC 101 1014 Uen B
D-9