User Guide Part 2

Connecting the LNA Cables Installing the RBS Remote Units
3-6 Ericsson Proprietary 92-F0423-1
Steps
To connect the LNA cables
 )RUDWZR5)PRGXOHLQVWDOODWLRQFRQQHFWWKH/1$FDEOHVIURPWKH/1$ILOWHUVWR
WKH5)PRGXOHVDVVKRZQLQ)LJXUH ¥RQSDJH 
 )RUDVLQJOH5)PRGXOHLQVWDOODWLRQFRQQHFWWKH/1$FDEOHVIURPWKH/1$ILOWHUV
WRWKH5)PRGXOHDVVKRZQLQ)LJXUH ¥RQSDJH DQGFDSFRQQHFWLRQV'(
DQG)
CAUTION
To avoid damaging the LNA cables, do not bend them to less than
1 inch (25.4 mm) in radius.
 7LJKWHQWKH/1$FDEOHHQGVFDUHIXOO\8VHDWRUTXHZUHQFKVHWWRWKHUHFRPPHQGHG
WRLQFKSRXQGVWR1FP
CAUTION
Do not use pliers to tighten the LNA cable ends; pliers can damage the
SMA connector body.
ATTENTION
Over- or under-tightening the LNA cable connections can cause
off-specification performance.