User's Manual

B2CH079AA Product Manual – ERM2, 5 GHz WLAN Radio Module
November 2007 Page 9 of 14
PM-B2CH079AA Version 2
* P2P indicates that the rated transmit power is only permissible for use in point-to-
point links. For point-to-multipoint or multipoint-to-multipoint links the power
must be reduced as shown.
+
These antennas require an external filter between the product and antenna, part
number BMA000281-A
Warning: Use of this module in conjunction with any antenna not expressly
listed above will void authority to install or operate this equipment.
Warning: Setting of module transmit power above the limits specified in the
above table for a particular combination of antenna type, frequency of operation,
and type of usage, will exceed FCC or Industry Canada limits and void authority to
install or operate this equipment.
Product Installation
Products which contain B2CH079AA-A shall only be installed by professional
installers trained by BelAir Networks or its authorized agents. In addition to normal
installation procedures and good installation practice, professional installers are
responsible to ensure that:
1. Only an approved antenna (see above) is connected to the module, and,
2. The antenna is mounted in such a manner and in such a location that access to the
antenna by the general population is minimized. Access to the antenna by the
general population should be limited to more than the minimum safety distance.
This distances are outlined according to product type and whether high gain
antennas are used: