B2CH072AA B2CH072AA Product Manual 4.9 GHz Public Safety Band Radio Module Document Date: Document Number: Document Version Number: Document Status: February 20, 2007 PM-B2CH072AA 2 Release © Copyright 2006 by BelAir Networks. All rights reserved..
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Contents About this Document ............................................................. 2 Introduction ............................................................................. 3 Conditions of Use.................................................................... 4 Module Installation and Service ............................................ 6 Final Product Requirements ..................................................
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Introduction The B2CH072AA(hereafter referred to as “the module”) is a 4.9 GHz radio module compatible with the IEEE 802.11 standard for Wireless LAN operation. It is designed to be interoperable with WLAN products which are based on Direct Sequence Spread Spectrum (DSSS) radio technology. The module contains a complete 802.11a radio and Medium Access Control (MAC) protocol engine which allows implementation of an 802.11a module.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Conditions of Use General Conditions of Use This manual is intended to supplement training provided by BelAir Networks or authorized parties. The module B2CH072AAis only intended for use in BelAir Networks products and is not for sale to the general public as a standalone module. Please read this entire document, including the Regulatory Statements section before attempting to install or operate the module.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Country of Use B2CH072AA is certified with limited modular approval for use as an Intentional Radiator in the United States as device: FCC ID: RAR20004001. Please read all regulatory statements at the end of this document before any attempt to install or operate this module. The module is only certified for operation in the United States.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Module Installation and Service Installation into a Product The module shall only be installed by a technician trained by BelAir Networks or its authorized agents. It should only be installed into an approved product (see above) following all manufacturing and service procedures for that product. The module should only be installed into a final product in a manufacturing or service depot site.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Final Product Requirements The requirements below apply to any final product in which the B2CH072AAmodule is installed. Antenna Usage and Module Transmit Power B2CH072AAmodule shall only be used in conjunction with the following antenna types as outlined in the table below. Antennas are approved for outdoor use only.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Product Installation Products which contain B2CH072AA-A shall only be installed by professional installers trained by BelAir Networks or its authorized agents.
B2CH072AA Product Manual –4.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module Regulatory Statements The following regulatory notes apply to the product which contains module B2CH072AA. The following sections or equivalent information shall appear in the user-manual of the final product. Regulatory Information and Disclaimers Installation and use of this device must be in strict accordance with the instructions included in the user documentation provided with the product.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module RF Exposure Radios Minimum Safety Distance Radios Other combinations Minimum Safety Distance BelAir50C BelAir50S Radios 1 x RAR20004001 (PSM1) w. 21 dBi antenna 40 cm ( 16 inches) NONE ------- BelAir100 BelAir100S BelAir100C Radios 1 x RAR20001003 and 23 dbi antenna 1 x RAR20004001 (PSM1) w. 21 dBi antenna 60 cm ( 24 inches) 1 x RAR20004001(PSM1) w.
B2CH072AA Product Manual –4.9 GHz Public Safety Band Radio Module BelAir Networks Inc. 603 March Road Kanata, Ontario Canada K2K 2M5 613-254-7070 Sales sales@belairnetworks.com Support support@belairnetworks.com General Information Info@belairnetworks.
