Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
Radio Configurations, RBS 2206
Table 16 2 x 6 configurations with CDU-G
CDU
TMA Antenna
No. / Connector
No. (TMA config.
only)
Cell 1
1 / TX / RX1
1
TX / RXA
1 / TX / RX2
2
TX / RXB
Cell 2 3 / TX / RX1
5
TX / RXA
3 / TX / RX2
6
TX / RXB
Table 17 3 x 4 configurations with CDU-F
CDU
TMA Antenna
No. / Connector
No. (TMA config.
only)
Cell 1 1 / TX / RX
1
TX / RXA
1/RX
2
RXB
Cell 2 2 / TX / RX
4
RXB
2/RX
3
TX / RXA
Cell 3 3 / TX / RX
6 RXB
3/RX
5
TX / RXA
Table 18 3 x 4 and 3 x 2 configurations with CDU-G
CDU
TMA Antenna
No. / Connector
No. (TMA config.
only)
Cell 1 1 / TX / RX1
1
TX / RXA
1 / TX / RX2
2
TX / RXB
Cell 2 2 / TX / RX1
4
TX / RXB
2 / TX / RX2
3
TX / RXA
Cell 3 3 / TX / RX1
6
TX / RXB
3 / TX / RX2
5
TX / RXA
Table 19 1 x 8 configurations with CDU-F
CDU
TMA Antenna
No. / Connector No. (TMA config.
only)
Cell 1 1 / TX / RX
1
TX / RXA
1 / TX / RX
3
TX / RXB
Alt cell 1
3 / TX / RX
3
TX / RXA
3 / TX / RX
5
TX / RXB
66 (421)
EN/LZT 720 0008 R1A
2001-06-26
© Ericsson Radio Systems AB
— All Rights Reserved —