Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
Glossary
MMI Man-Machine Interface
MO Managed Object
MR Measurement Receiver
MS Mobile Station
MSC Mobile services Switching Centre
GSM network unit for switching, routing
and controlling calls to and from the
Public Switched Telephone Network
(PSTN) and other networks.
MSTP Mobile Station Test Point
Multidrop Two or more RBSs are connected in a
chain to the same transmission system.
All the relevant timeslots are dropped out
by each RBS. (This function is sometime
called cascading.)
NEBS Network Equipment Building System
NMS Ericsson Network Management System in
DXX
Nominal Power The nominal power is the power level
defined when configuring the transceiver.
N terminal Neutral terminal in a AC mains connection
O&M Operation and Maintenance
General term for activities such as
configuration, utilization of channels
(frequency bands), cell planning, system
supervision, hardware and software
maintenance, subscriber administration,
and so forth.
OMC Operation and Maintenance Centre
OML Operation and Maintenance Link
Layer 2 communication link for operation
and maintenance services on Abis.
OMT Operation and Maintenance Terminal
The OMT is a terminal that supports
functions for handling the RBS on site.
The terminal can be a portable PC.
Operation Operation is the normal, everyday running
of the RBS with full functionality.
OPI OPerational Instructions
EN/LZT 720 0008 R1A
2001-06-26
415 (421)
© Ericsson Radio Systems AB
— All Rights Reserved —