Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
BTS Parameter Limitations
52.4 Appendix
ICP
TS1
132
133
134
TRX 0: 512-523
TRX 1: 524-535
TRX 2: 536-547
TRX 3: 548-559
TRX 4: 560-571
TRX 5: 572-583
TRX 6: 640-651
TRX 7: 652-663
TRX 8: 664-675
TRX 9: 676-687
TRX10: 688-699
TRX 11: 700-711
135
TS2
136
512
137
513
SCH
138
514
139
515
TCH´s
TRX0
signalling
(RSL/OML)
PCM-B
140
516
141
517
1
142
518
2
519
3
250
520
4
251
521
5
TS31
252
522
6
253
523
7
254
255
01_0300B
.
ATSR 0
TS1
4
5
6
7
TS2
8
9
10
11
PCM-A
12
13
14
122
123
TS31
124
125
126
127
.
.
.
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
.
.
348
349
350
351
o
o
o
o
o
o
o
o
260
261
262
263
o
256
257
258
259
o
o
o
348
349
350
351
260
261
262
263
256
257
258
259
o
.
.
ICP
SCH1
SCH2
SCH24
CCP
IS
o
o
o
o
o
o
o
o
o
o
o
.
CON
.
TS 64 kbit/ PSM timeslot
ATSR Air time slot resource
SCH Signalling channel
TCH Traffic channel
Figure 113 Physical mapping of entities and ICP/CCP
Note: TS25 – TS31 are only applicable for 2048 kbit/s systems.
Each ICP (IS Connection Point) or CCP (CON Connection Point)
represents a 16 kbit/s connection point. They are numbered from 4 to
711. A 16 kbit/s channel is established by connecting two ICPs to each
other. A 32 or 64 kbit/s signalling channel is established by connecting
two or four pairs of consecutive ICPs to each other. The consecutive
ICPs must belong to the same TS or SCH.
EN/LZT 720 0008 R1A
2001-06-26
405 (421)
© Ericsson Radio Systems AB
— All Rights Reserved —