Reference Manual

Operation and Maintenance Terminal
Read Copy the IDB from the RBS to the OMT.
Install Install the IDB from the RBS to the OMT.
Cable mounting list Display a cable mounting list based upon
information from the IDB.
Site specific data Site specific data , that is IDB information
that is changeable from the OMT, is
displayed, copied to any file medium to
the IDB in the OMT.
Save Copy the IDB from the OMT to any file
medium, for example a floppy disk or a
hard disk.
Open Copy the IDB from any file medium to
the OMT.
Inventory list An inventory list, containing RU data,
based upon information from the IDB, is
displayed, saved on file medium or
printed.
Configure Generate a new configuration.
Reconfigure Copy data from the old IDB to the new.
Modify Increase or decrease the number of
activated RUs in the IDB.
The functions above are for general purpose use.
42.3.5 External Alarms
The following user functions, related to the external alarms, are
available in the OMT:
•
Display external alarm setup, display the external alarm setup
parameters (see chapter External Alarms) associated with each of
the external alarm inputs
• Define external alarm setup
• Monitor external alarms status, the status (on/off) of the external
alarms is continuously monitored and displayed
The output can be displayed or directed to file (output stored in a file on
the OMT).
The functions above are normally used at
• installation (display/define external alarm setup)
• site acceptance (monitor external alarms status)
The fault status for all inlets defined for auxiliary faults can be
monitored.
324 (421)
EN/LZT 720 0008 R1A
2001-06-26
© Ericsson Radio Systems AB
— All Rights Reserved —