Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
Product Safety Requirements RBS 2000
2 Product Safety Requirements RBS 2000
The purpose of this document is to specify the product safety
requirements for RBS 2000.
2.1 References
73/23/EEC Low Voltage Directive
CAN/CSA-C22.2 No 1-M94
Audio, Video and Similar Electronic Equipment
CAN/CSA-C22.2 No 950-95
Safety of Information Technology Equipment
Including Electrical Business Equipment
EN 60950 Safety of Information Technology Equipment
Including Electrical Business Equipment
IEC 215 Safety requirements for radio transmitting equipment
IEC 529 Classification of degrees of protection provided by
enclosures (IP Code)
IEC 60950 Safety of Information Technology Equipment
Including Electrical Business Equipment
UL 1419 Standard for Professional Video and Audio
Equipment
UL 1950 Safety of Information Technology Equipment
Including Electrical Business Equipment
2.2 Product Safety
This part of the document defines the Electrical, Mechanical, Heat and
Fire Safety Requirements for the Radio Base Station.
General
The RBS is designed to comply with the following International
Standards:
•
73/23/EEC Low Voltage Directive. (To achieve this, the RBS
shall conform to the standards below.)
• EN 60950 "Safety of Information Technology Equipment
Including Electrical Business Equipment".
• The RBS fulfils the requirements in the general IEC 60950
including national differences notified in EN 60950.
• IEC 215 Safety requirements for transmitting equipment.
• The RBS shall be listed by National Recongnized Testing
Laboratory (NRTL).
• The RBS fullfills encapsulation class IP XX according to
IEC 529.
EN/LZT 720 0008 R1A
2001-06-26
17 (421)
© Ericsson Radio Systems AB
— All Rights Reserved —