Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
Common Control Channel Handling
However, if more than one IA is sent in the same
IMMEDIATE_ASSIGNMENT_EXTENDED message on air interface,
the same number of IMMEDIATE_ASSIGNMENT_SENT messages
should be sent on Abis.
16.2.4 CCCH Dequeuing and Transmission
Downlink CCCH capacity is used for PAGING as well as for access
grant (IMMEDIATE ASSIGN).
The RBS supports:
•
Dequeuing and scheduling
• Packing of messages
• Selection of Page Mode
• Retransmission of messages
• Dummy paging
•
Transmission of system information 7, 8, 13, 16 and 17
Handling of Paging is covered in the section Paging above. Handling of
Immediate Assign is covered in section Immediate Assign above.
Supported Logical Channels /GSM:05.02:3.3.3/:
AGCH Access Grant Channel
PCH Paging Channel
Dequeuing and Scheduling
The RBS dequeues and transmits messages from the CCCH queue
system in the following order of priority, where a) has the highest
priority:
a) SYSTEM_INFORMATION
b) IMMEDIATE_ASSIGNMENT
•
/GSM:04.08:9.1.18/
•
/GSM:04.08:9.1.19/
c) IMMEDIATE_ASSIGNMENT_REJECT
• /GSM:04.08:9.1.20/
d) IMMEDIATE_ASSIGNMENT for Paging Group
e) IMMEDIATE_ASSIGNMENT_REJECT for Paging Group
f) PAGING_REQUEST
If no messages are queued for transmission:
• IMSIs, TMSIs and IAs stored for retransmission (see section
Retransmission of Messages below) are sent at the same priority
level as described above.
• If no messages are stored for retransmission, "Dummy Paging" is
used (see section Dummy Paging below).
EN/LZT 720 0008 R1A
2001-06-26
169 (421)
© Ericsson Radio Systems AB
— All Rights Reserved —