Reference Manual
Table Of Contents
- RBS 2206 Reference Manual
- Contents
- Preface
- Product Safety Requirements RBS 2000
- Environmental Capabilities
- Scope
- Terminology
- References
- Transport -40 C - +70 C
- Storage -25 C - +55 C
- Handling -40 C - +70 C
- Operation Indoor +5 C - +40 C
- Operation Outdoor -33 C - +40 C
- Operation Outdoor -33 C - +45 C
- Operation Outdoor -33 C - +55 C
- Operation Mast Mounted Equipment -33 C - +45 C
- Operation Mast Mounted Equipment -33 C - +55 C
- Radio Configurations, RBS 2206
- Product Data
- Unit Description, DXU-21
- Unit Description, dTRU
- Unit Decription, CDU-G and CDU-F
- Unit Description, CXU-10
- Unit Description, FCU-01
- Unit Description, DC-Filter 01
- Unit Description, PSU 1200 W
- Unit Description, ACCU/DCCU
- Unit Description, IDM
- Broadcast
- Common Control Channel Handling
- Physical Channel Handling
- Speech and Data Services
- Packet Data Services
- Call Control
- References
- Channel Activation
- Adaptive Frame Alignment
- Asynchronous Handover Detection
- RF Channel Release
- Deactivate SACCH
- Link Establish Indication
- Link Release Indication
- Link Establishment Request
- Link Release Request
- Transparent Message Transmission
- Transparent Message Reception
- SACCH Info Modify
- LAPDm
- Channel Reactivation
- Power Information
- GPRS, Physical Link Layer
- Base Station Power Control
- Channel Measurements
- Discontinuous Transmission
- Frequency Hopping
- Encryption
- Mode Modify
- Mobile Station Power Control
- Short Message Service
- Diversity Supervision
- Synchronization
- Radio Reception
- Radio Transmission
- Frequency Allocation Support
- Restart and Recovery
- Function Change
- Functionality Administration
- Operation and Maintenance Support
- References
- Concepts
- Buttons
- Change RU to Local Mode
- Change RU to Remote Mode
- Change RU to Remote Mode Cancel
- Change SW Power Boost Slave RU to Local Mode
- Loop Control
- RF Loop Test Supervision
- Calendar Time Request
- RSSI Temperature Compensation
- Max Cooling
- Fault Indicator
- BS Fault Indicator
- Operational Indicator
- Tx Not Enabled Indicator
- Local Mode Indicator
- External Alarms Indicator
- DC Disconnected Indicator
- Battery Mode Indicator
- Bat Disconnected Indicator
- AC Fault Indicator
- Test Result Indicators (not used)
- Local Mode in Progress
- Installation Data Handling
- Self Test and Supervision
- Diagnostics and Fault Handling
- Operation and Maintenance Terminal
- External Alarms
- Handling of Auxiliary Equipment
- Climate Protection
- EMC Capabilities
- Transmission Interface Handling G.703 2048 kbit/s
- Transmission Interface Handling DS1 1544 kbit/s
- Terrestrial Link Handling
- Channel Distribution Function
- Transport network O&M functions-DXX Support
- BTS Parameter Limitations
- Glossary
Common Control Channel Handling
16 Common Control Channel Handling
"Common Control Channel Handling" denotes the RBS resources
utilised for traffic on the Common Control channel.
16.1 References
/GSM:04.08/
/GSM:08.58/
/GSM:05.02/
/GSM:05.03/
Whenever a reference is made to a function described in another chapter,
please refer to the table of contents to find the appropriate chapter.
16.2 Function
16.2.1 Paging
By means of the PAGING procedure /GSM:08.58:5.2/, the RBS pages
mobiles on command from the BSC. The RBS supports:
•
Reception, interpretation and check of PAGING_COMMANDs
from BSC
•
Queuing of IMSI and TMSI
• Scheduled transmission of PAGING_REQUEST messages on PCH
• Retransmission of PAGING_REQUEST messages on PCH
•
EMLPP priority information in the PAGING_REQUEST
Channel combinations /GSM:05.02:6.4/ supported:
•
(iv) FCCH+SCH+BCCH+CCCH
•
(v) FCCH+SCH+BCCH+CCCH+SDCCH/4(0..3)+SACCH/
C4(0..3)
PAGING_COMMAND messages from BSC with the following MS
IDENTITY (Id-type) are supported:
IMSI International Mobile Subscriber Identity
TMSI Temporary Mobile Subscriber Identity
IMSIs and TMSIs are queued for scheduled transmission on PCH. One
paging queue is supported for each paging group.
The following messages are used for scheduled transmission of IMSI
and TMSI is made with:
• PAGING_REQUEST_TYPE_1 /GSM:04.08:9.1.22/
• PAGING_REQUEST_TYPE_2 /GSM:04.08:9.1.23/
• PAGING_REQUEST_TYPE_3 /GSM:04.08:9.1.24/
For dequeuing, priority handling, selection of Page mode, transmission
and retransmission, see Section 16.2.4 on page 169.
EN/LZT 720 0008 R1A
2001-06-26
167 (421)
© Ericsson Radio Systems AB
— All Rights Reserved —