Product Description
Limited Internal
PRODUCT DESCRIPTION 10 ( 27 )
EAB/SEMCON Staffan Paulusson EN/LZT 720 0491 Uen
EAB/RKW Lena Jonsson Borg 2004-12-28 R1A
Prepared (also subject responsible if other) No
Approved Checked Date Rev Reference
E
The compliance boundary is defined as a cylinder around the antenna, see
Figure below. The antenna is not located at the centre of the cylinder. Instead
it is located almost at the edge, facing towards the center of the cylinder.
The distance between the antenna’s rear and the edge of the cylinder is the
"Distance behind antenna". The height of the cylinder is the antenna height
plus equal distances above and below the antenna. The cylinder shape
overestimates the compliance distances right beside the antenna.
Figure 5 Compliance Boundary Cylinder
Note table 4 shows an example for a typical antenna. As the
antenna field distributions will differ, complete calculations or
measurements may be necessary in order to establish the
compliance boundary for other configurations chosen by the
customer. For further information on calculation methods, see:
Radio Site Installation Engineering Manual EN/LZT 720 0399