User's Manual Part 3

RBS 2308 and RBS 2309 User’s Guide
13. Loosen the two securing screws
under the IXU, and remove the
unit.
P010365B
14.
Remove the cover for the flash
card. To remove the flash card,
lift up the release lever and then
push it in.
P010366A
15.
Remove the cover for the flash card. Insert the old flash card in the
new unit and push it down and reset the release lever, ensuring that
the flash card is in position.
16.
If PCM tr
ansmission is used:
Open the
cover of the new IXU and set the switch positions on the TIM
in acco
rdance with installed transmission cables.
17.
Mount the connection frame delivered with the new IXU into the old
IXU, and close the cover.
18. Mount the IXU and secure it with the two screws under the IXU.
19.
If IP-based transmission is used:
Put back the PSTU. Tighten the screws to 1.7 Nm.
20.
Connect the Y-link cables. Ensure that the Y-link cables are connected
to the correct connectors.
21.
Mount the connection frame and connect all cables. Close the IXU
cover.
22.
Connect the earth cable and the AC/DC cable.
224
EN/LZT 720 0027 Uen R8A 2006-06-27