User's Manual Part 3

RBS 2308 and RBS 2309 User’s Guide
9.
Remove the TIM after loosening
the three screws.
P010374B
(x 3)
10.
Remove the IFB after loosening
the seven screws.
P010360A
11.
Put back the new IFB, the connection frame, and all cables.
12. Put back the TIM. Tighten the screws to 1.7 Nm.
13.
Secure the Y-link cables.
14. Reconnect the IXU cover.
Putting the RBS into Operation
15.
Switch on the AC power and DC power.
16.
Close the RRU.
17.
Inform the OMC operator that the applicable cells are to be put into
service.
18.
Press the Local/Remote button on the IXU to set the RBS to remote
mode. Wait until the RF off indicator on the RRU interface panel goes
off and the Operational indicator lights up.
19.
Close the sunshields.
218
EN/LZT 720 0027 Uen R8A 2006-06-27