User's Manual Part 3

RBS 2308 and RBS 2309 User’s Guide
state. See figure below. This sequence is repeated throughout the function
change process.
Figure 78 Function Change Indication When Operational Indicator Is On
Indication of a Function Change When Operational Indicator Is Off
When a function change is initiated and the Operational indicator is off, it starts
to double-flash and is off during indicator old state. See figure below. This
sequence is repeated throughout the function change process.
Figure 79 Function Change Indication When Operational Indicator Is Off
Before Maintaining an RBS Indicating a Function Change
Before performing any further operations on an RBS t hat is indicating function
change, do one of the following:
• If the Operational indicator is double-flashing on the IXU, indicating that a
file transfer is in progress (normally followed by RUs indicating function
change), wait for a few minutes; if the Operational indicator on the IXU
continues to double-flash, contact the OMC operator for further instructions
or to request a start command on SO CF
• If the Operational indicator is double-flashing on an RU, which indicates
that a function change is in progress, wait 1 or 2 minutes until a function
change restart has been made
1
95
EN
/LZT 720 0027 Uen R8A 2006-06-27