User's Manual Part 2

RBS 2308 and RBS 2309 User’s Guide

9 RBS Site Integration

This chapter describes how to integrate the RBS with the BSC into the GSM

network, and the tests used to verify the integration.

Integration is carried out with the RBS connected to a transmission link (PCM

or Ethernet) and in close co-operation with a BSC operator.

All results must be documented in the test record.

Preconditions at the RBS Site

This section describes the preconditions for personnel at the RBS site before

integrating the RBS.

Before starting the integration at the RBS site, ensure the following:

• The test record for Antenna System Tests has been completed

• The test record for Site Installation Tests has been completed

• If a PSTU is used in the RBS 2308, then it must be in the operational state

traffic handling and the transmission between the PSTU and the BSC

sub-node Packet Gateway (PGW), must be established

• If a PSTU is used in the RBS 2308 and the PSTU is used to synchronize

the RBS, then the PSTU must be in synchronization status synchronized

• The RBS commissioning personnel are in contact with the BSC operator

• The RBS commissioning personnel and the BSC operator have agreed

on the following parameters:

− BCCHNO parameters

− DCHNO parameters

− BSIC parameters

− Time slots (TS) used for SDCCH

Preconditions at the BSC

This section describes the preconditions for personnel at the BSC before

integrating the RBS.

Before starting the integration at the BSC, ensure the following:

• The test record for Network Element (NE) has been completed

/LZT 720 0027 Uen R8A 2006-06-27