User Manual
Table Of Contents
- toc
- RBS Product Description
- 1 Introduction
- 2 Product Overview
- 3 Dimensions
- 4 Space Requirements
- 5 Environment
- 6 Hardware Units
- 7 Interfaces
- 8 Power System
- 9 Transmission
- 10 External Alarms
- 11 Standards, Regulations and Dependability
- RBS Product Description
- tables
- Table 1 Weights
- Table 2 Colour
- Table 3 Environmental Specifications
- Table 4 Compliance Boundary Dimensions for the General Public (G
- Table 5 Characteristics for a Typical Antenna (KRE 101 1916/1)
- Table 6 Maximum Power to Antenna for Various RBS Configurations
- Table 7 RBS 2206 External Connections
- Table 8 RBS 2206 V2 External Connections
- Table 9 AC Power Requirements
- Table 10 Fuse Specifications
- Table 11 Fuse Specifications
- Table 12 +24 V DC Power Requirements
- Table 13 Fuse Specifications
- Table 14 Fuse Specifications
- Table 15 Requirements
- Table 16 Fuse Specifications
- Table 17 Fuse Specifications
- Table 18 Power Consumption RBS 2206
- Table 19 Power Consumption RBS 2206 V2
Ericsson Internal
DESCRIPTION 25 ( 34 )
/ XSNSIXI 19/1551-LZA 701 0001 Uen
CBC/ XRX/M ( Kai Lian) 2011-05-05 G
Prepared (also subject responsible if other) No.
Approved Checked Date Rev Reference
Connection
Description
Connector Type
FCU RD Optical cable connector
from the BBS
Opto connector
+24 V DC DC filter Cable clamp
Earth Earth stud M8 to main earth
cable
M8 stud
ACCU Mains connection to
PSU-AC
Screw terminal
DCCU
48 V connection to
PSU-DC
Screw terminal
ASU Antenna sharing
connections
SMA-connector
TMA-CM DC power supply through
bias injectors to the TMAs
SMA-connector
DXX Transmission link TNC-connector
GPS Synchronization signal from
GPS antenna
9-pin female, D-sub
7.2 RBS 2206 V2 External Connections
This section describes the external connections of the RBS 2206 V2.
The RBS does not have connection fields on the upper right- and left-hand
sides of the cabinet. Cables are instead connected directly to the DXU.