User Manual
Table Of Contents
- toc
- RBS Product Description
- 1 Introduction
- 2 Product Overview
- 3 Dimensions
- 4 Space Requirements
- 5 Environment
- 6 Hardware Units
- 7 Interfaces
- 8 Power System
- 9 Transmission
- 10 External Alarms
- 11 Standards, Regulations and Dependability
- RBS Product Description
- tables
- Table 1 Weights
- Table 2 Colour
- Table 3 Environmental Specifications
- Table 4 Compliance Boundary Dimensions for the General Public (G
- Table 5 Characteristics for a Typical Antenna (KRE 101 1916/1)
- Table 6 Maximum Power to Antenna for Various RBS Configurations
- Table 7 RBS 2206 External Connections
- Table 8 RBS 2206 V2 External Connections
- Table 9 AC Power Requirements
- Table 10 Fuse Specifications
- Table 11 Fuse Specifications
- Table 12 +24 V DC Power Requirements
- Table 13 Fuse Specifications
- Table 14 Fuse Specifications
- Table 15 Requirements
- Table 16 Fuse Specifications
- Table 17 Fuse Specifications
- Table 18 Power Consumption RBS 2206
- Table 19 Power Consumption RBS 2206 V2
Ericsson Internal
DESCRIPTION 26 ( 34 )
/ XSNSIXI 19/1551-LZA 701 0001 Uen
CBC/ XRX/M ( Kai Lian) 2011-05-05 G
Prepared (also subject responsible if other) No.
Approved Checked Date Rev Reference
P016585A
DCCU-13
ACCU-11/DCCU-11
CDU
ASU
Connection
Field
ASU
Connection
Field
TMA-CM DXU
TMA power
GPS
ESB
EPC
Alarms
Transmission
OMT
Figure 10 RBS 2206 V2 External Connections
Antenna feeders are directly connected to the CDUs. If bias injectors are
used, then they are connected directly to the CDU, and the antenna feeder is
connected to the bias injector.