User Manual
Table Of Contents
- toc
- RBS Product Description
- 1 Introduction
- 2 Product Overview
- 3 Dimensions
- 4 Space Requirements
- 5 Environment
- 6 Hardware Units
- 7 Interfaces
- 8 Power System
- 9 Transmission
- 10 External Alarms
- 11 Standards, Regulations and Dependability
- RBS Product Description
- tables
- Table 1 Weights
- Table 2 Colour
- Table 3 Environmental Specifications
- Table 4 Compliance Boundary Dimensions for the General Public (G
- Table 5 Characteristics for a Typical Antenna (KRE 101 1916/1)
- Table 6 Maximum Power to Antenna for Various RBS Configurations
- Table 7 RBS 2206 External Connections
- Table 8 RBS 2206 V2 External Connections
- Table 9 AC Power Requirements
- Table 10 Fuse Specifications
- Table 11 Fuse Specifications
- Table 12 +24 V DC Power Requirements
- Table 13 Fuse Specifications
- Table 14 Fuse Specifications
- Table 15 Requirements
- Table 16 Fuse Specifications
- Table 17 Fuse Specifications
- Table 18 Power Consumption RBS 2206
- Table 19 Power Consumption RBS 2206 V2
Ericsson Internal
DESCRIPTION 13 ( 34 )
/ XSNSIXI 19/1551-LZA 701 0001 Uen
CBC/ XRX/M ( Kai Lian) 2011-05-05 G
Prepared (also subject responsible if other) No.
Approved Checked Date Rev Reference
Note: ICNIRP, "Guidelines for limiting exposure to time-varying electric,
magnetic, and electromagnetic fields (up to 300 GHz)", International
Commission on Non-Ionizing Radiation Protection, Health Physics,
vol. 74, no. 4, 1998.
Ericsson has performed a free-space near-field RF exposure assessment
of typical configurations of the RBS with a recommended antenna. The
resulting dimensions, in metres, for a compliance boundary for both public and
occupational exposure are shown in Table 4.
The compliance boundary is defined as a cylinder around the antenna, see
figure below. The antenna is not located at the centre of the cylinder. Instead
it is located almost at the edge, facing towards the centre of the cylinder.
The distance between the antenna’s rear and the edge of the cylinder is the
"Distance behind antenna". The height of the cylinder is the antenna height
plus equal distances above and below the antenna. The cylinder shape
overestimates the compliance distances right beside the antenna.
Figure 6 Compliance Boundary Cylinder
Note: Table 4 shows an example for a typical antenna. As the antenna field
distributions will differ, complete calculations or measurements may
be necessary in order to establish the compliance boundary for other
configurations chosen by the customer. For further information on
calculation methods, see Radio Frequency Electromagnetic Fields.