User Manual
Table Of Contents
- toc
- RBS 2107
- 1 Product Overview
- 2 Dimensions
- 3 Space Requirements
- 4 Environment
- 5 Hardware Units
- 6 Interfaces
- 8 Transmission
- 9 External Alarms
- 10 Standards, Regulations and Dependability
- RBS 2107
- tables
- Table 1 RBS 2107 Weights
- Table 2 RBS 2107 Colours
- Table 3 Climatic Requirements
- Table 4 Compliance Boundary Dimensions for the General Public (G
- Table 5 Characteristics for a Typical Antenna (KRE 101 1916/1)
- Table 6 Maximum Power to Antenna for Various RBS 2107 Configurat
- Table 7 Cable Gland Capacity
- Table 8 Optional Configurations in the DF
- Table 9 OVP Modules Capacity
- Table 10 Antenna Connections
- Table 11 External Connections
- Table 12 Switches and Circuit Breakers
- Table 13 Power Parameters
- Table 14 Mains Fuses Recommendation
- Table 15 Output Power
- Table 16 Power Consumption
RBS 2107
1.2 Variants
The following variants are available and can be combined according to ordering
information:
• Two standard colours
• AC service outlet (four variants depending on fields of application)
• Base frame, 250 mm (709/BYB 415 01/08)
1.3 Optional Equipment
The equipment listed below is available but not necessary for basic operation:
• Battery backup
• Bias injector
• DC/DC converter
• DC filter
• dual duplex Tower Mounted Amplifier (ddTMA)
• Digital Cross Connector (DXX) – two card
• External Synchronization Bus (ESB)
• External alarms
• GPS (mounted externally)
• Keys (operator specific keys)
• MINI LINK
• OverVoltage Protection (OVP)
• Redundant Power Supply Unit (PSU)
• Smoke detector
• Tower Mounted Amplifier-Control Module (TMA-CM)
• Transmission adapter (75
to 120 )
• RX-Splitter 01
2 Dimensions
This section describes the dimensions and colour of the RBS 2107.
4 (28)
E
N/LZT 720 0491 Uen R2A