User Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Product Overview
- 3 Dimensions
- Size and Weight
- Surface and Colour
- 4 Space Requirements
- Footprint
- 5 Environment
- 6 Hardware Units
- 7 Interfaces
- 7.1 External Connections
- Connections on DF
- Overvoltage Protection Modules in the RBS 2106i and RBS 2106 V3
- Overvoltage Arrestors for External Alarms in the RBS 2106
- Antenna Connections
- Other External Connections
- External Connections to TM
- Transport Network to TM
- 7.2 Test Interface
- 7.3 Operator Interface
- Indicators
- Buttons
- 8 Power System
- 8.1 Power Supply
- AC Mains Supply Voltage
- External Earth Fault Circuit Breakers
- Mains Fuses
- 8.2 Battery Backup
- Internal Battery Backup
- External Battery Backup
- 8.3 Output Power to TM
- 8.4 Power Consumption
- 9 Transmission
- Optional Transmission Equipment
- 10 External Alarms
- 11 Standards, Regulations and Dependability
PRELIMINARY
RBS Product Description
7 Interfaces
This section lists all external connectors, as well as the test interface and the
operator interface.
Internal connections, the test interface, and the operator interface are located
on some cabinet hardware units.
7.1 External Connections
All external connectors enter through the bottom of the cabinet. The
approximate locations of the connection fields are shown in the figure below, to
aid in planning cable inlet allowances.
Figure 13 External Interfaces
32
129/1551-LZA 701 0001 Uen PF1 | 2010-10-08