User's Manual Part 1

RBS 2109 User’s Guide
Danger!
Never look directly into the end of a fiber optic cable, or other laser source.
Equipment that transmits laser light can cause permanent eye damage. Switch
off the laser before starting work on laser equipment.
Safety Precautions for Working with Class 3 Laser
The following precautions must be observed when working with products
containing a Class 3 laser hazard symbol:
• Never look into the light emitting end of a functioning optical fibre.
• Switch off units producing the laser signal before disconnecting an optical
fibre.
2.11 Chemical Hazards
This section provides information on chemical hazards that can be present
in products.
2.11.1 Beryllium Oxide Hazard
This section provides information on Beryllium Oxide (BeO). BeO is a restricted
substance that is contained in certain components in some Ericsson products.
If a product contains BeO, this is clearly marked on the unit containing BeO.
The BeO hazard symbol is shown in the figure below.
P010382A
Figure 12 BeO Hazard Symbol
Note: This information only applies to products marked with the BeO symbol.
19EN/LZT 720 0090 Uen R1A 2004-09-17