User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2101Macro Outdoor
OVP – Overvoltage Protection module
The OVP protects the RBS equipment from overvoltage and overcurrent which
may occur in external lines.
Number of units: 0 – 1.
TMA - Tower Mounted Amplifier
The TMA is mounted near the antennas and compensates for signal loss in
the receiver antenna cables. The unit is enclosed in a weatherproof box and
operates on +15 V DC power.
Number of units: 0 – 2.
6 Interfaces
In this section all external connections are listed, and the test and operator
interfaces are described.
P005296B
TX1 TX2
RX1
RX2
EXT. ALARM GPS/ESB
TM-48V
TM+24V
BUS-1
BUS-2
G703-2
G703-1
EXT.T
DOOR
ESB
Figure 4 RBS 2101 Interfaces
12 (18)
E
N/LZT 720 0219 Uen R2A