User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2101 Macro Outdoor
5.3 Climate Sub-cabinet
The RBS 2101 is provided with either an Air Conditioner Climate Unit or a
Heat Exchanger Climate Unit.
AC – Air Conditioner Climate Unit
The AC is a compressor and condensor cooling system that cools the RBS
sub-cabinets.
A heater is included in this climate unit to provide the RBS with heat during
cold climate conditions.
Number of units: 0 – 1.
Heat Exchanger Climate Unit
The Heat Exchanger Climate Unit consists of a recuperator with one fan for the
internal circuit and one for the external circuit.
A heater is included in this climate unit to provide the RBS with heat during
cold climate conditions.
Number of units: 0 – 1.
5.4 Optional Hardware Units
DC/DC Converter
The DC/DC converter provides -48 V DC power for the TM.
Note: If no DC/DC converter is used, a dummy panel has to be installed.
Number of units: 0 – 1.
ddTMA - dual duplex TMA
The ddTMA is mounted close to the antennas. It amplifies the receiver signal
and combines it with the transmitter signal. The combined signal is transmitted
on a single feeder between the ddTMA and CDU. A bias injector is required
for power.
Number of units: 0 – 2.
11 (18)
EN/LZT 720 0219 Uen R2A