User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2101, RBS 2102, RBS 2103 and RBS 2202 Hardware Reference Manual
Table 14 Environmental parameters for mast-mounted equipment, -33
C
– +45
C
Environmental parameters Unit Value
Change of temperature
C/min
6
(1)
Rain intensity mm/min
6
Air pressure kPa
70-106
Heat radiation W/m² neglible
Solar radiation W/m²
1120
(2)
Movement of air m/s
50
Condensation
yes
Winddriven particle
yes
Water other than rain splashing
Icing
yes
(1) The requirement belong to ’Exceptional/Safe Function’ and will occur for maximum 3 minutes.
(2) Solar radiation. Based on IEC 60721-2-4 the requirement shall be verified by applying 896
W/m², for verification method see ref. /Solar/.
3.11.3 Biological Conditions
The severity of these requirements are in conformity with: IEC 60721-3-4 class
/4B1/. and ETSI EN 300 019-1-4 Class 4.1
Table 15 Biological conditions for mast-mounted equipment, -33
C – +45
C
Environmental parameters Value
Flora Presence of mould, fungus etc.
Fauna
none
3.11.4 Chemically Active Substances
The severity of these requirements are in conformity with: IEC 60721-3-4
classes /4C2(4C1)/. and ETSI EN 300 019-1-4 Class 4.1
21
EN/LZT 720 0023 Uen R3B 2010-06-10