User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
ECUEnergy Control Unit
• Cooler control
• Fan control
• Climate sensor
• System voltage
• Battery voltage
Note: The ECU could be powered from either D-sub on the front panel
(24 V AC) or from the backplane.
5.2 Operator Interface
This section describes the operator interface consisting of connectors, optical
indicators and buttons.
Connectors
The connectors on the front of the ECU are the following:
• Power control bus (opto)
• AC Mains (transformed to low voltage)
Optical Indicators
The optical indicators in the table below are located on the front of the ECU.
Table 4 ECU Optical Indicators
Indicators
Colour
Fault Red
Operational Green
Battery mode Yellow
DC disconnected Yellow
AC fault Yellow
8 (10)
EN/LZT 720 0245 Uen R1A