User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
ECU Energy Control Unit
5 Interfaces
This section describes the following interfaces on the ECU:
• Signal and power interfaces
• Operator interface
P003419A
ECU
OPTO
TD
RD
To
AC-
unit
CPUReset
Fault
Operational
Battery mode
DC disconnect
AC fault
View of backplane
DC Control
Local bus
Heater control
Cooler control
Fans control
Climate sensor
System voltage
Battery voltage
Figure 2 Interfaces
5.1 Signal and Power Interfaces
The following signal and power interfaces are available via the backplane.
• DC control
• Local bus
• Heater control
7 (10)
EN/LZT 720 0245 Uen R1A