User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
CDU-DCombining and Distribution Unit
Table 4 CDU-D Indicators
Indica-
tor
Colour
Mode Description
Off No faults detected in CDU-D
On One or more faults detected in CDU-D
Fault Red
Flashing • IDB missing in DXU
• Loss of communication to a superior RU
• RBS SW missing (CU only)
Off CDU-D not operational
On CDU-D operational
Opera-
tional
Green
Flashing SW being downloaded (CU only)
Ericsson AB
SE-116 64 Stockholm
Sweden
asq.us@ericsson.com
No part of this document may be reproduced in any form without
the written permission of the copyright owner.
The contents of this document are subject to revision without
notice due to continued progress in methodology, design and
manufacturing.
Ericsson shall have no liability for any error or damages of any
kind resulting from the use of this document.
© Ericsson AB 2003 — All Rights Reserved
12 (12)
EN/LZT 720 0279 Uen R1A