User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
CDU-DCombining and Distribution Unit
5.1 Signal and Power Interface
This section describes the signal and power connections on CDU-D.
Table 3 Signal and Power Connectors
Unit
Connection Connector Type
TX in2 TNC female
TXio 1, TX io2 Combining network
Pfin,Pi1,Pi2,Prin SMA female
CU
CDU bus in 9-pin male, D-sub
TX Ant N female
RX out N female
Prefl 1, Prefl 2, Prefl 3 SMA female
Pfwd 1, Pfwd 2, Pfwd 3 SMA female
Pf test, Pr test SMA female
CDU Bus in, CDU Bus out 9-pin male, D-sub
FU and
FUd
DC in,
DC out
2-pin
male Molex Mini-Fit
RX AntA, RX AntB N female
HL out A1, HL out A2, HL in A SMA female
HL out B1, HL out B2, HL in B SMA female
RXA out 1 – 6, RXB out 1 – 6 SMA female
CDU Bus in 9-pin male, D-sub
DU
DC in 2-pin male Molex Mini-Fit
10 (12)
EN/LZT 720 0279 Uen R1A