User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
Combining and Distribution Unit
5.1 Signal and Power Interface
This section describes the signal and power connections on CDU-C+.
Table 3 Signal and Power Connectors
Connection Connector Type
TX in1, TX in2
TNC female
TX/RX Ant
N female
DPX/RX SMA female
RX in, RX in B
N female
RXA out1 – 2, RXA out 3 – 6
SMA female
Prefl 1, Prefl 2
SMA female
Pfwd 1, Pfwd 2
SMA female
HL in
SMA female
HL out and HL out B
SMA female
CDU Bus
9-pin male, D-sub
DC in
2-pin male Molex Mini-Fit
5.2 Operator Interface
This section describes the operator interface, which consists of optical
indicators located on the front panel, see figure and table below.
P010469A
CDU-C+
Fault
Oper.
TX in 1 TX in 2
RX in
Figure 4 CDU-C+ Indicators
7
EN/LZT 720 0278 Uen R1B 2010-08-09