User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
BFU Battery Fuse Unit
Connectors
The following connector is located on the front of the BFU:
• AUX fuse
Optical Indicators
This section describes the BFU optical indicators.
Table 4 BFU optical indicators
Label
Colour
Mode Indication
Off No faults detected.
On One or more faults detected.
Fault Red
Flashing The unit has detected a
communication fault on the
power communication loop.
(1)
Off BFU is not operational.
On BFU is operational.
Operational Green
Flashing The unit has detected a
communication fault on the
power communication loop.
(2)
Off Battery is connected.Battery
disconnect
Yellow
On Battery is disconnected.
(1) BFU revision 2 or later
(2) B
FU revision 1
Circuit Breaker
Table 5 Circuit breaker
Label Position Description
ON
(1)
Battery power to the RBS connectedCircuit breaker
OFF
(2)
Battery power from the RBS disconnected
(1) Normal position
(2) Position when released
9 (10)
EN/LZT 720 0233 Uen R1A