User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
BFUBattery Fuse Unit
5.1 Signal and Power Interfaces
The signal and power interfaces are located on the rear of the BFU unless
otherwise indicated.
Signal
A signal interface is located on the rear of the BFU for the following:
• DC control
• Temperature sensor
• ECU control
On the front panel of the BFU is an optical fibre link (Opto) for communication
with the ECU.
Power
The power interfaces consist of the following:
• System voltage to the RBS
• Battery voltage (See Figure 2 on page 7.)
5.2 Operator Interface
This section describes the operator interface consisting of connectors, optical
indicators and a circuit breaker.
P006248C
Fault
Operational
Bat.disconnect
Aux fuse
(T1,6A 220V)
BFU
Circuit breaker
BFU top view
Position when
released
Normal position
Front
Figure 3 BFU optical indicators and circuit breaker
8 (10)
EN/LZT 720 0233 Uen R1A