User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2202Antenna Configurations
4.4.3 1x6 CDU-C+ without Duplexer
J
D
A
H
2
1
3
2
1
3
2
1
3
2
1
3
Ant
TX
RX
Cell A
Ant
TMA
TX
RX
TMA
TX RX Ant
TMA
P010133A
Figure 17 1X6 CDU-C+ without duplexer
Table 17 1x6 CDU-C+ without Duplexer
Cell CDU
Feeder label
Connector Signal
A:TX1 H1 TX 11
A:RXA H2 RX A
A:TX2 H3 TX 22
A:RXB J3 RX B
A
3 A:TXB J2 TX 3
From this 1x6 CDU-C+ configuration, the following configuration can be derived:
• 1x4 CDU-C +
The following configuration requires three cabinets, each configured as in
Table 17 on page 26:
• 3x6 CDU-C +
26 (32)
EN/LZT 720 0 342 Ue n R1A