User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2202 Antenna Configurations
3.4.2 1x6 CDU-D w ithout Duplexer
P010129A
J
D
A
H
3
2
1
3
2
1
3
2
1
3
2
1
Cell A
Figure 8 1x6 CDU-D without Dup
lexer
Table 8 1x6 CDU-D without Duplexer
Cell CDU
Feeder label
Connector Signal
A:TX1 A3 TX
A:RXA A1 RX A
A 1
A:RXB D1 RX B
From this 1x6 CDU-D configuration, the following configurations can be derived:
• 1x2 CDU-D
• 1x4 CDU-D
The following three-cell configurations require three cabinets, each configured
as in Table 8 on page 13.
• 3x2 CDU-D
• 3x4 CDU-D
• 3x6 CDU-D
13 (32)
EN/LZT 720 0342 Uen R1A