User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2101, RBS 2102, RBS 2103 RBS 2202 Radio Configurations
Dual Band configurations with mixed CDU types
RBS 2102 and RBS 2202 dual band configurations with mixed CDU types
are shown in the table below.
Table 12 Dual Band Configurations with Mixed CDU Types
TMA
Cell or sector:
Number of
Antennas
Cell or sector:
Allowed
number
of TRUs
Cell or sector:
SCC Configuration
1 2 3 1 2 3 1 2 3
1x2 |
1x2
2xA9d_2.2 + C+18_2.2
(1)
no no M 2 2 2 0–2 0 0–2
2xA9
d_2.2 + C+18d_2.2
(1)
no no no 2 2 2 0–2 0 0–2
2xC+9d_2.2 + A18_2.2
(1)
no no M 2 2 2 0–2 0 0–2
2xC+9de_2.2 + A18_2.2
(1)
no no M 2 2 2 0–2 0 0–2
C+9d_2.2 + A18_4.2 N/A N/A no 2 2 4 0–2 0 0–2
C+9de_2.2 + A18_4.2 N/A N/A no 2 2 4 0–2 0 0–2
1x4 |
1x2
C9d_2.4 + A18_2.2 no M N/A 2 2 N/A 2–4 0–2 N/A
C9d_2.4 + A18_4.2 N/A no N/A 2 4 N/A 2–4 0–2 N/A
C+9d_2.4 + A18_2.2 no M N/A 2 2 N/A 0–4 0–2 N/A
C+9de
_2.4 + A18_2.2
no M N/A 2 2 N/A 0–4 0–2 N/A
C+9d_2.4 + A18_4.2 N/A no N/A 2 4 N/A 0–4 0–2 N/A
C+9de_2.4 + A18_4.2 N/A no N/A 2 4 N/A 0–4 0–2 N/A
C9d_2.4 + C+18_2.2 no M N/A 2 2 N/A 2–4 0–2 N/A
C9d_2.4 + C+18d_2.2 no no N/A 2 2 N/A 2–4 0–2 N/A
(1) Two cells are equipped in the cabinet, but three cells must be selected in the OMT.
M = Mandatory
N/A = not applicable
Note: There are always two choices to place equipment in a cabinet:
GSM 900 on the left-hand side and GSM 1800 on the right-hand side,
or vice versa.
61 (74)
EN/LZT 720 0341 Uen R1A