User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2202 Macro Indoor RBS
Table 9 External Cable Connectors – EDGE Upgrade
Connector
Plate
Connector
Number
Description
1 Transmission line 5
2 Transmission line 4
3 Transmission line 3
4 External alarms
5 XTL-bus to Extension Cabinet
6 Transmission line 2
7 Transmission line 1
8 Y-link to Extension Cabinet (sTRU 1–3)
9 Y-link to Extension Cabinet (sTRU 4–6)
10 External Synch Bus (TG sync)
11 External Synch Bus (TG sync)
C
12 GPS Connection
G Earth
6.2 Test Interface
The OMT connector provides an interface for the Operation and Maintenance
Terminal. The OMT provides a graphical user interface (GUI) and is used to
verify that the Installation Database (IDB) is installed and contains the correct
equipment configuration information. The OMT can be used to perform the
following:
• Display software version
• Create or modify the IDB
• Define external alarms
• Modify or display O&M parameters
• Define PCM interface
• Define TMA parameters
• Monitor and display fault status
17 (20)
EN/LZT 720 0223 Uen R2A