User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2202 Macro Indoor RBS
07_0076B
115
o
1000
800
1000
Unit of measurement: mm
Figure 2 Space Requirements in Relation to Additional Equipment
Footprint
The footprint of the RBS 2202 is 598 mm wide and 400 mm deep. The
installation frame of the RBS 2202 has the same bottom holing pattern as
that of the RBS 2206.
Unit of measurement: mm
P008315C
RBS 2202
RBS 2206
FRONT
99
400
598
220
45
320
400
o 20x75
Figure 3 Ba
se Frame and Installation Frame Holing Pattern
7 (20)
EN/LZT 720 0223 Uen R2A