User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Product Safety Requirements RBS 2000
- 3 Environmental Capabilities
- 3.1 Scope
- 3.2 Terminology
- 3.3 References
- 3.4 Transport -40 C – +70 C
- 3.5 Storage -25 C – +55 C
- 3.6 Handling -40 C – +70 C
- 3.7 Operation Indoor +5 C – +40 C
- 3.8 Operation Outdoor -33 C – +40 C
- 3.9 Operation Outdoor -33 C – +45 C
- 3.10 Operation Outdoor -33 C – +55 C
- 3.11 Operation Mast-Mounted Equipment -33 C – +45 C
- 3.12 Operation Mast-Mounted Equipment -40 C – +55 C
- 4 Climate Protection
- 5 EMC Capabilities
- RBS 2101, Product Description
- RBS 2102, Product Description
- RBS 2103, Product Description
- RBS 2202, Product Description
- RBS 2101, 2102, 2103 & 2202 Radio Configurations
- RBS 2202 Antenna Configurations
- ACCU Description
- BFU Description
- CDU-A Description
- CDU-C Description
- CDU-C+ Description
- CDU-D Description
- DXU Description
- DXU-21 Description
- ECU Description
- PSU -48 V Description
- PSU 230 V Description
- sTRU Single Transceiver Unit Description
- V3 Climate Unit Description
- Glossary
RBS 2103 Macro Outdoor
6 Interfaces
In this section all external connections are listed, and the test and operator
interfaces are described.
6.1 External Connections
External connections provided by the RBS 2103 include the following:
• Transmission
• Antenna
• AC mains
•OMT
•Externalalarms
•Earth
Table 5 External Cable Connectors
Connector
Name
Description
Bus-
1
Loca
l bus connector for extension cable
Bus-2 Local bus connector for extension cable
Door Alarm sensor connector for door alarm
Ext.Alarm External alarm connector
Ext.T External temperature sensor alarm connector
G.703–1 Transmission interface port
G.703–2 Transmission interface port
RS232
RX1 Receiver antenna port 1
RX2 Receiver antenna port 2
TM-48V Transport Module connector f or -48 V power connection
TM+24V Transport Module connector for +24 V power connection
TX1 Tran
smitter antenna port 1
TX2 Transmitter antenna port 2
15 (20)
EN/LZT 720 0221 Uen R1A