User Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Product Overview
- 3 Dimensions
- Weight
- Colour
- 4 Space Requirements
- Space above the RBS Cabinet
- Layout for RBS Cabinets
- Earthquake Requirements
- Footprint
- 5 Environment
- 6 Hardware Units
- 6.1 RBS 2206 Standard Hardware Units
- ACCU-01
- CDU
- CXU-10
- DCCU-01
- dTRU
- DXU-21
- FCU
- IDM-01
- PSU
- DC Filter-01
- 6.2 RBS 2206 V2 Standard Hardware Units
- ACCU-11
- CDU
- CXU-10
- DCCU-11
- DCCU-13
- dTRU
- DXU-23
- IDM-11
- PSU
- 6.3 Optional Hardware Units
- ASU-01
- Bias Injector
- BBS
- ddTMA
- DXX
- DF
- ESB
- HCU
- 19-inch Space for Optional Equipment
- OXU
- Splitter
- TMA-CM-01
- TMA-CM-02
- 7 Interfaces
- 8 Power System
- 9 Transmission
- Overvoltage Protection Modules
- Optional Transmission Equipment
- 10 External Alarms
- 11 Standards, Regulations and Dependability
RBS Product Description
IDM-01
The Internal Distribution Module (IDM) is a panel for distributing the internal
+24 V DC power to the various units. Each distribution circuit in the cabinet is
connected to a circuit breaker in the IDM.
Number of units: 1
PSU
The Power Supply Unit (PSU) are available in two versions, PSU AC for
connection to AC mains, or PSU DC for connection to
0
48 or
0
60 V DC power
supply.
• The PSU-AC converts 120–250 V to regulated +24 V DC
• The PSU-DC converts
0
48 or
0
60 V DC to regulated +24 V DC
Number of units: 0, 2, 3, 4
DC Filter-01
The DC filter unit is the interface for +24 V DC power supply or battery backup.
Number of units: 0–1
6.2 RBS 2206 V2 Standard Hardware Units
This section briefly describes the standard hardware units required for
functionality, irrespective of configuration or frequency.
16
19/1551-LZA 701 0001 Uen PG1 | 2010-10-08