Specifications

Any change of the configuration SMS is accompanied by a restart of the GSM

module.

Note:

Format DTMF 4x2 describes events in such a manner that necessary information is

presented by means of 6 HEX digits “AAAAEZ”, where:

- “AAAA” is the client’s account number;

- “E” is the event code;

- “Z” is the zone/user number

For format Ademco PID, the interface will not generate clear SMS messages.

Notes:

In the edit mode, digits can be obtained directly, by pressing the corresponding

keys longer.

The comma and period can be obtained by successively pressing key “1”.

Upon editing, each key is used for several symbols: i.e. letter „C” is obtained by

successively pressing key “2” for 3 times.

Press shortly key “*” in order to switch from capital to small letters or vice versa; “*”

also modifies the last edited character from capital to small letter or vice versa.

Keys “Æ” and “Å” are used to move the slide to the right and left within the edited

message. By long pressing these keys, the slide is directly moved to the beginning

or end of the edited message.

Key “CLR” (Clear) is used to delete the character on the right or left of the slide.

6. Save this SMS, with no destination phone number, in the phone memory (not the

card’s);

Example for Ericsson A1018s:

In the edit mode, after the configuration message was edited, press key “Yes”. The

destination phone number will be answered to with “NO”. If there is the case, to

modify an existent message, answer with key „NO” to the “Store?” and “Erase?”

questions.

Note: There must be only one message stored in the mobile phone that is the

configuration SMS message. Older messages must be erased. The number of

SMS messages in the card’s memory is not restricted.

Example for Ericsson A1018s:

- press keys “Å ” then “Yes” to unlock the keypad (if there is the case);

- press key “Å ” successively for 2 times. “Mail” menu will show up.

- press key “Yes”. “Read messages” menu will show up. Press key “Yes”.

- press key “Å ” or “Æ” until the message to be erased was found.

- press key “Yes”. Enter the message reading mode. If the current message is not

the one to be erased, press key „NO” and restart looking it up. If the current

message is the one to be erased, press key “CLR”. Press key „YES” to answer

“Erase?” question. In case “Store?” question shows up, answer “No”.