Specifications

10
3x Burglary Alarm on zone x
4x Medical emergency Medical emergency
5x Tamper Ambush
6x Bypassed zone Bypass zone x
9x Periodical Test Periodical Test
Bx Disarming Disarm by code x
Cx Arming Arm with code x
Ex Restoring Zone x restoring
Fx Trouble Trouble on zone x
Others Unknown code
X = zone or user number
Programming mode:
1. Disconnect the GSM module from the power supply (both mains supply and 12V
battery), if it was previously loaded.
2. Disconnect the GSM phone from the GSM module (JR1);
3. Deactivate the PIN code according to the phone user manual;
4. Enter the programming mode of the GSM phone, in menu “Mail”, then “Send
Message”;
Example for Ericsson A1018s:
Buttons “Å” and “Æ” are for scrolling command menus and sub-menus on the
same level.
Button “Yes” is used for entering the submenus of the current command menu.
Button “No” is used to exit the current menu and return to the main menu.
Keys “Yes” and “No” are for positive or negative answers to current questions that
the GSM phone user is asked.
- press keys “Å ” then “Yes” in order to unlock the keypad (if the case);
- press key “Å ” twice. Menu “Mail” appears.
- press key “Yes”. Menu “Read messages” appears.
- press key “Æ”. Menu “Send message” appears.
- press key “Yes”. Sub-menu “New” appears.
- if the GSM phone has not been used to program the GSM module before or if the
GSM phone does not contain any SMS for GSM communicator setting
(programming):
- press key “Yes”.
- if the GSM communicator is reprogrammed or if there is a GSM module
programming SMS in the GSM phone:
- press key “Æ” once or several times until the configuration SMS appears
on the display;