User's Manual
Table Of Contents
- toc
- Installation Instruction
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Prerequisites
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Earth Grounding RRU-N
- 3.2.5 Connecting the -48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation Power Supply Unit-AC Kits
- 6 Optional Installation External Hybrid Combining Unit
- 7 Performing Concluding Routines
- 8 Verifying the Installation
- Installation Instruction
- tables
Ericsson Internal
INSTALLATION INSTR. 32 ( 37 )
/ XKUEMHU 50/1531-LZA 701 0001 Uen
CBC/ XRX ( Jan-Erik Thillberg) 2009-03-09 C
Prepared (also subject responsible if other) No.
Approved Checked Date Rev Reference
3.
Loosen the captive screws on
the cover of the PSU-AC, and
open the cover.
K000252B
4.
Connect the conductors as
shown in the picture. Tighten
the wire connected to the
terminal block to a torque of 1.0
– 1.2 Nm.
Note: Ensure that the wires
are connected to the correct
polarities respectively.
K000473B
0V 48V
_
LNPE0V 48V
_
L N PE
0V 48V
_
Incoming AC
Power
Supply
Output
Power
Cable