User's Manual
Table Of Contents
- toc
- Installation Instruction
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Prerequisites
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Earth Grounding RRU-N
- 3.2.5 Connecting the -48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation Power Supply Unit-AC Kits
- 6 Optional Installation External Hybrid Combining Unit
- 7 Performing Concluding Routines
- 8 Verifying the Installation
- Installation Instruction
- tables
Ericsson Internal
INSTALLATION INSTR. 30 ( 37 )
/ XKUEMHU 50/1531-LZA 701 0001 Uen
CBC/ XRX ( Jan-Erik Thillberg) 2009-03-09 C
Prepared (also subject responsible if other) No.
Approved Checked Date Rev Reference
4.
Start to apply the self-amalgamating
(self-fusing) tape approximately
50 mm below the lower edge of
each connector. Overlap each turn
by 50%. Proceed all the way up to
the edge of the splitters.
Vary the stretching of the tape and
avoid spaces.
5.
Apply two, half-overlapped,
slightly-stretched layers of
electrotape. For each layer,
start 30 mm below the lower end of
the self-amalgamating (self-fusing)
tape and proceed all the way up to
the edge of the splitters.
5 Optional Installation Power Supply Unit-AC Kits
Caution!
Stop! Do not install or modify AC or DC powered equipment unless you are a
qualified and authorized electrician. Improper installation work can seriously
damage the equipment.
The RRU-N should be equipped with Power Supply Unit-AC (PSU-AC) kits to
adopt the AC power. The PSU-AC can be ordered as an optional part.