Installation Instruction

RBS Installation Instructions
4.4 Installing DC power
1. Install the PSU-AC-41 in the position
where it is to be located.
Note: Depending on the wall, it may
be necessary to drill the holes for
the screws.
P018111B
4.5 Connecting Cables
Following interfaces in the RBS 2409 are available:
• Ethernet (transmission)
• DC power
• External Antenna (optional)
• Y-link (if using extension RBS)
• Configuration (Configuring the RBS or the STN)
1. Connect the OMT cable to the
configuration port for configuration
of the RBS.
Make sure the RBS is powered up.
For parameter settings, see the
Site Installation Documentation and
document Setting IDB Parameters.
When finished configuring, detach
the OMT cable.
8 41/1531-LZA 701 0001 Uen D 2008-04-23