User's Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Preconditions
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Grounding RRU-N
- 3.2.5 Connecting the 48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation External Hybrid Combining Unit (EHCU)
- 6 Performing Concluding Routines
- 7 Verifying the Installation
- tables
RBS Installation Instructions
1.
Enter the free ends of the clamps
into the openings in the mounting
bracket and pass them through
as shown. The diameter of the
pole may very between 40 and
160 mm.
Note: The two pieces of
pole clamps must be ordered
separately.
K000418B
2.
Apply the clamps around the
pole. Insert the free end of
the clamp into and trough the
screw-nipple. Tighten the screw
to 5.5 Nm.
K000423B
ANT A ANT B
26 50/1531-LZA 701 0001 Uen PA4 2008-07-31