User's Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Preconditions
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Grounding RRU-N
- 3.2.5 Connecting the 48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation External Hybrid Combining Unit (EHCU)
- 6 Performing Concluding Routines
- 7 Verifying the Installation
- tables
Optional Installation External Splitter/Highway Function
4 Optional Installation External
Splitter/Highway Function
Caution!
Stop! This product contains components sensitive to ESD. Use an approved
ESD wrist strap, connected to the product grounding point, to avoid damaging
these components.
Note: The antenna system must have been tested. For more information, see
Verifying Antenna Systems, 1/1532-LZA 701 0001.
This section describes how to install the external splitter on a pole/mast and
how to connect the cables.
1.
Loosen the screw of the
mounting clamp, using a flat 6
mm screwdriver.
2.
Route each of the mounting
clamp through the mounting
plate of the splitter. Place them
in the correct position on the pole
and tighten the screw.
K000419A
2350/1531-LZA 701 0001 Uen PA4 2008-07-31