User's Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Preconditions
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Grounding RRU-N
- 3.2.5 Connecting the 48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation External Hybrid Combining Unit (EHCU)
- 6 Performing Concluding Routines
- 7 Verifying the Installation
- tables
Installation RRU-N
3.
Cut the power supply cables to the appropriate length.
4.
Strip approximately 60 mm of
the outer layer of insulation from
the power cable, as shown in
the picture. Leave approximately
10 mm of the inner conductors.
5.
Remove the cable gland nut
from the cable gland using a
24 mm open-ended wrench.
Remove the protective plug and
the inner seal from the cable
gland (marked PWR).
K000349C
PWR
5 Nm
1550/1531-LZA 701 0001 Uen PA4 2008-07-31