Use and Care Manual

Item no: 07494
STEP 2: ATTACHING HARDWARE
• Flip the carrier 180 degrees so the support bracket is now on the bottom.
• Align the left side locking plate (#8) with the top two holes on the corner of the carrier.
• Use Insert the Lifting Bolt (#7) with M10 Lock Nut (#5) in the top hole and M10 Hexagon Socket
Button Head Screws Screw (#6) with M10 Lock Nut in the bottom hole.
• Repeat the above steps with the right side. (Only 1 plate in Parts List)
• See FIG 2 for illustration.
STEP 3: ATTACHING FOLDING BAR
• Align the top two holes one on the Folding Bar (#9) with the holes on the end of Support Bracket.
• Slide the M16 Bolt (#12) through the holes closest to carrier and tighten with M16 Lock Nut
(#11).
• Slide the 5/8” Locking Pin (#13) through the holes closest to the vehicle and secure with the
Safety Pin Pin Clip (#10).
• See FIG 3 for illustration.
FIG 2
FIG 3
PARTS NEEDED
#5 M10 lock nut
#6 M10 head screw
#7 Liing bolt
#8 Locking Plate
PARTS NEEDED
#9. Folding Bar
#10. Safety Pin
#11. M16 Lock nut
#12. M16 Bolt
#13. 5/8’’ Locking Pin
#
#
#
#
#
#
#
#
#
#